Todas as mensagens

voxtel Solidred means standby. Means no input from bound controller. Solid green means link with controller established. Going back and forth means it's failsafing. Try moving your GCS away from the XM .

2020-12-22 09:40:19 Útil (0)
Enviar
respostas (2)

Q: does it have a spar included?

perguntado por Rommel sobre 2019-06-19 01:38:52

part_t1me_nerd no just the foam pieces

2019-09-20 02:23:32 Útil (0)
Enviar
respostas (1)

part_t1me_nerd To flash new betaflight, do not solder the boot pads. Connect usb click "Connect" and enter "dfu" into the CLI command window, it will automatically disconnect and enter DFU mode. If not, it may have to install DFU drivers (it should do this by itself automatically), connect again (you may have to unplug USB then plug in again) and enter "dfu" into CLI command line, it should enter DFU mode on the second attempt.

Turbo 11/01/2017
I just installed this in a new build I did last night, it's the EX105 frame and Chaoli 2S motors and I have the FC in 2S position. I'm using a SBUS micro RX from the one used on that little quad and the other QX ones. I have rolling spider props on it, and the camera/vtx from the QX series and a one Lumenier 500mAh 2S 50C lipo and a Tattu 650mAh 75C 2S batter. I have it configured in Betaflght as what it comes installed with 3.0.0 and I for some reason or another(and if anyone knows or can help I'd appreciate it) couldn't get the F4 FC to go into DFU mode in the cofiguratior?? I can connect and configure and I did so, but I'd really like to put 3.0.1 on it badly!! And for the life of me don't know why it will not flash?? I've tried what I think they are not labeled here or on the board the boot pins and tried to get it to go that way and no dice. Anyway, I haven't got to fly it yet and I'm so mad!! I got it totally built last night and was planning on trying it out today and of course the wind was blowing 25mph ALL DAY LONG I'm hoping like heck it doesn't blow like that tomorrow for I HAVE GOT TO FLY THIs THING!! It seems to have tons of power for a brushed quad! It weighs 73 grams with battery in flight ready state!! That is with the 500mAh I hanen't even put the 650 on to see what the weight is that way but it is a little bigger Cross your fingers and wish hard for me so tomorrow I'll get to try my 2S brushed creation out!! I'll leave some pics below of my Brushless BEAST!! I also as the other gentleman stated am at currently 4% CPU and running 8GhZ on both as well!! IT's an awesome flight controller for the micro builds for sure!! Thanks Banggood KEEP UPTHE GOOD WORK!!! Thanks for reading!-Turbo.
7
Comentários (1)

part_t1me_nerd What gyro and PID loop frequency did you use?

DonKracho 08/10/2017
0
Comentários (2)

Q: how many tvl and what is min lux?

perguntado por part_t1me_nerd sobre 2018-01-29 11:33:29

Heat It is 1200TVL.

2018-02-05 04:07:22 Útil (0)
Enviar
respostas (1)