Minhas perguntas

Q: What are the dimensions of this; how big or small is it?

perguntado por mbogelund sobre 2019-01-15 08:50:26

babapro31 width 10cm excluding wheel

2022-05-14 02:45:43 Útil (0)
Respostas (2)

Nico80 Hi! Highest diameter is 1.8mm, min is 1.2 in the middle. Length is 3.5mm. Standard 1:6w resistor size. My Fluke Dmm says the 1% tolerance is there!! 100k=100.0kohm Perfect!

2020-02-29 11:17:45 Útil (1)
Respostas (2)

Q: What is the diameter of the inlet nozzle?

perguntado por mbogelund sobre 2017-12-21 02:15:52

BG478573815 I have ordered the ID 1848558 hot air gun ,will these fit this gun

2021-10-07 02:45:00 Útil (1)
Respostas (3)

Q: Are they breadboard friendly?

perguntado por mbogelund sobre 2017-12-06 02:53:33

fortwonator ifthey are breadboard compatible, the terminals are flexible.

2021-05-08 08:32:23 Útil (0)
Respostas (2)

Q: Will the output voltage stay the same even if I change the load on the output?

perguntado por mbogelund sobre 2020-07-22 08:20:22

OGHagen Most buck converters when used within limits keep the output voltage pretty well assuming the load increase slowly. A sudden increase in load will usually cause a drop in voltage. However the load vs ... Ver mais

2020-09-06 20:17:12 Útil (1)
Respostas (2)

Q: Which mounting bracket can I buy that fits this gear motor?

perguntado por mbogelund sobre 2019-01-07 08:26:53

Frapson How many pieces would you like?

2019-01-31 03:17:23 Útil (0)
Respostas (1)