kotec
Q: The seven stroke don't work ! I have only the screen " >150 V!" It's like the internal voltage référence of the micro-controler is bad or at 0 volts. The voltage on pins 19 and 20 are 0 Volts ( no currant and no load) and the device detect >150V . I think that the chip is dead . I can change it for a new if you can send me a good ( I am an electronicien with 40 year of pratice :-) ) Can send Ver mais
perguntado por kotec sobre 2020-08-06 13:30:26
Mondegreen This product should not support serial input/output and protocols.
2020-08-05 20:52:24 Útil (2)
Hubi-Dirk Manual,Section "Mode button function description", Point 5: If no load connected stroke Mode button seven times for factory reset.
2020-08-04 23:13:47 Útil (2)
Aliay Yes,but need 7.4V DC power supply,or use 18650 battery.
2019-12-30 00:51:11 Útil (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Glitter You can send the fault diagram to the customer service for processing. I think you may have triggered the protection by mistake.
2020-08-09 22:04:44 Útil (0)