Todas as mensagens

Q: I thought this was a VTOL aircraft. Is it only fixed wing, and not VTOL?

perguntado por Donald sobre 2023-12-02 06:23:13

BG391735534 this ad is fixed wing, but you can buy the kit vtol

2024-03-15 05:42:35 Útil (0)
Enviar
respostas (1)

Q: What is the radiation hazard from the radioactive luminous handle?

perguntado por Donald sobre 2020-10-31 07:50:11

raivis11 its not radioactive.. its just reflecting light, nothing else

2022-02-06 11:58:10 Útil (1)
Enviar
respostas (5)

AviationAddict The blunt edge of the propeller is the direction it turns when looking directly at the propeller from the front for a fixed wing, or from the top for a quad-copter.

2024-01-13 04:55:11 Útil (1)
Enviar
respostas (2)

Q: Are the shank sizes 4mm or 1/4in?

perguntado por Donald sobre 2018-09-09 08:07:56

Sujay Das battery conjunction too high but too good

2023-10-21 08:21:16 Útil (0)
Enviar
respostas (1)

Q: how many watt?

perguntado por Fornosi sobre 2023-03-29 10:50:00

Donald Watts are Volts time Amps pulled. To answer your question you need to provide the battery voltage you will use and the load, i.e. the prop diameter and pitch, and its expected amp draw. Of course the retailer should have already provided a chart with the recommended props for the voltages this motor can handle. Since they don't, it's up to you to guess that and hope you're right!

2023-09-25 04:07:57 Útil (1)
Enviar
respostas (1)

Donald Brushless motors wires do not have polarity like brushed motors. The 3 wires alternately pulse each set of magnets inside the motor acting more like AC current, not DC current. As already mentioned, swapping any 2 of the 3 wires changes direction of the motor. Some ESC programmers can also do that without changing wires.

2023-09-25 03:57:38 Útil (1)
Enviar
respostas (2)

Donald Most BL motors can spin in either direction by changing any 2 of the 3 wires powering it. But if the motor spins the same direction as the prop nut, the nut will eventually spin itself off the prop shaft unless you use a Nyloc nut or secure the nut after it's on so that it cannot move unless you remove the wire or the clevis pin. Some use a second nut over the first but a liquid like Locktite should be used in that case.

2023-09-25 03:39:49 Útil (1)
Enviar
respostas (3)

Q: Can I use a 6s batterie with this motor?

perguntado por ismaelbiber sobre 2020-09-19 06:06:30

Donald The specs only show up to 4S. You will most likely burn up the motor is you use a battery higher than 4 cells.

2023-09-20 04:27:25 Útil (1)
Enviar
respostas (2)

mszulen You mean an inrunner vs outrunner? The Inrunner (the case with Freewing) is easier to install. Check if your motor has threaded holes in the back (if yes - it's even easier to install). Otherwise you can use zip ties to the back of the motor (INRUNNER ONLY) via the cooling holes.

2023-09-12 10:07:45 Útil (0)
Enviar
respostas (1)

mszulen Look at the balancer connector. It does not get the full 6s voltage. It's made to get 3s only from the connector. You could use it even on 10s :)

2023-09-12 10:02:24 Útil (0)
Enviar
respostas (1)