Todas as mensagens

Q: Which props can i use as spare Part?

perguntado por MadMase83 sobre 2021-10-16 02:53:24

CorpseGuard 6x4 would be the best if you want destroy the stock setup.

2022-03-17 12:49:36 Útil (0)
Enviar
respostas (4)

Q: Is it a RHCP or LHCP antenna?

perguntado por BG523347494 sobre 2021-11-19 07:50:01

CorpseGuard Rhcp

2021-11-19 07:53:08 Útil (0)
Enviar
respostas (1)

Q: Which target for flashing Betaflight?

perguntado por CorpseGuard sobre 2020-12-14 11:14:36

Johnnysod As said before Matek405 However the other comment about voltage is incorrect The VTX supply voltage is 10v but the accepted voltage on the new design is Input voltage & power dissipation: 7V~24V, +12V 260mA@600mW So is fine. Just add an extra wire to get smart audio on port 3. The flight controller is the one listed for the Tyo129. Quite nice. Has lots of ports. Add GPS if you want. Buzzer connection and S6 for Cam control if you upgrade the camera to say Cadex Ratel

2020-12-15 03:37:41 Útil (3)
Enviar
respostas (5)

Q: Should i laminate this little plane? If so how thick the film should be?

perguntado por muniramuminovic sobre 2020-09-21 01:03:50

CorpseGuard No need for that. I had a crash. It crashed down in a tree and it has no scratches 😁👍

2020-09-21 01:14:21 Útil (1)
Enviar
respostas (3)

Q: For what there is TXD pin?

perguntado por molor sobre 2020-02-25 11:47:02

CorpseGuard Are your pad without epoxy? They secure the signal and gnd with a big drop off epoxy.

2020-08-11 02:52:00 Útil (0)
Enviar
respostas (2)