Melhores ofertas para - Banggood Brazil Compras on-line

tfuse you can wire 5v either where you've mentioned or via the plug terminal underneath the board near the SD card reader. this allows you to make a super clean build with an ESC that has a plug terminal as well.

2017-12-28 02:21:34 Útil

Enviar

respostas (1)

Omnibus F4 BetaFlight 3.2.0 OSD STM32F405RGT6 Controlador de Voo para RC Drone FPV Racing 30.5X30.5MM

US$26.77 US$34.77

Q: I used the ribbon cable connector at the bottom of the board to get vbat and current, however, I am not seeing these values on the OSD. Do I need to enable a setting on the software or wire vbat elsewhere?

perguntado por tfuse sobre 2017-12-27 11:16:25

prylmannen Did you get voltage shown in Betaflight with this board? I powered it thru 5v but can´t get any voltage info. You used the connector to get it working?

2018-04-05 02:02:03 Útil

Enviar

respostas (1)

Omnibus F4 BetaFlight 3.2.0 OSD STM32F405RGT6 Controlador de Voo para RC Drone FPV Racing 30.5X30.5MM

US$26.77 US$34.77

Q: How is it powered? Cannot see any lipo power pads? Any manual included?

perguntado por Tyrivh sobre 2017-11-17 12:52:23

tfuse It's powered from a 5v input. The input is either on the bottom of the board (as oriented in the 1st photo) or powered on the underside board with the supplied cable. This board can be used for either 4in1 ESCs or 4 independent ESCs.

2017-11-26 09:27:05 Útil

Enviar

respostas (1)

tfuse I am banging my head trying to find out more about this ESC problem... I cannot flash this 4 in 1 and I am becoming more frustrated with having to replace it. The acro flight with this quad is aweful.

AvalancheSJ 11/06/2017

The Eachine Falcon 120 (Like all of the Falcon series) does not have damped light enabled. The product page says it is a 20a Blheli_S 4-IN-1 ESC but blheli suite does not recognize the FW installed and I cannot enable damped light. Aside from having sloppy acro flight due to the ESC the quad is actually quite powerful and fun. The frame is only 2mm thick but is stiff enough so far. The camera and VTX are good but the cloverleaf is too short so I replaced it with a longer one. The top plate fits my x6b 10ch receiver snugly. The lights are nice but the buzzer is pretty weak I can't really even hear it over the quad so unless I'm right on top of it it probably won't do me much good. My battery is old and probably has a dead cell but it has good punch on a 3s and I'd imagine it's a rocket on a 4s. If you don't mind crappy flight characteristics you can leave the ESCs I on the other hand plan on swapping it out for a Racerstar 20a Blheli_S 4-IN-1 ESC ASAP. Just my 2 cents.

Eachine Falcon 120 CC3D NAZE32 F3 Fpv racer arf com 4 em 1 esc 700 tvl câmera 5.8g 40ch VTX

US$139.00

4

Comentários (1)

tfuse So you just plugged the quad into blheli configurator and you were able to upgrade the ESCs? I was not able to detect the ESCs. I was wondering if you could elaborate more on how you were able to upgrade the ESCs.