Comentários

phil-le-b on my printer i have been using the stocking setting which is 60.c for the bed and 200.c for the hot end maybe ill try 190 but tbh i have been getting very good prints

Meultaine 26/04/2020
4
Comentários (2)

phil-le-b would you say its 3x times stronger then PLA because they say the ST-PLA is 3x times stronger jQuery19108048351943165182_1587506969673???

LacksAgency 26/12/2019
1
Comentários (1)

phil-le-b and me i had problem my vtx would turn off after 30sec due to the bec can only give 500mah which is not anuff to run a vtx and cam :( i had to use a 12v bec and wire that up

damian 26/09/2016
2
Comentários (4)