respostas

watageek You cannot use it to feed the motor, the purpose of a step down is to lower the input voltage to, example, 5volt to a flight controller or to feed 12 volt LED from a 4S-5S lipo. You could ( not saying you should) isolate the flight controller and use 3S on the lizard95. ESC/motor may burn.

Útil (0)
Enviar
respostas (7)

Q: Whichwireis for what? Black is for Ground and what is with orange and grey?

perguntado por dominic.e135 sobre 2019-03-27 21:56:43

watageek Grey is signal and orange is 3.3v input

Útil (1)
Enviar
respostas (1)

watageek Most of the time, yes on any free UART. Keep in mind there is sometime inverter transistor. Select corresponding UART in configurator for serial_RX.

Útil (0)
Enviar
respostas (1)

watageek Lite and normal support dshot300 max Bb1 chip 6g average. Lite_S (9g) and V2 (6g) are BB2 chip support dshot600 max.

Útil (1)
Enviar
respostas (2)

Q: Measurements? Because "suitable for 2205 motors" is like saying nothing...

perguntado por Kikerumbo sobre 2017-11-30 09:05:35

watageek ... but 693 should be 8mm od x 4mm thick x 3mm id. Not 8x3x3. This is not 693?

Útil (0)
Enviar
respostas (3)