Uma parte da revisão foi traduzida automaticamente.
A estrutura de expansão vale absolutamente o preço. A área original de 405x415mm foi substituída por 405x950mm de espaço de trabalho utilizável. Isso é mais do que o dobro do original! 950 mm em vez de 415 mm. O kit inclui dois trilhos longos, 4 bandas de borracha e um novo cabo de controle. Os novos trilhos têm uma cor ligeiramente mais clara do que os originais. A diferença principal, além do comprimento, é que os novos trilhos não têm uma régua. Eu fiz uma descrição de como atualizar, que eu anexo para você. (Veja abaixo) Convertido com o www.DeepL.com/Translator (versão gratuita)
I received this expansion kit, before the SCULPFUN S9 arrived. The kit is very well packet. You get 4 y-axis belts, of which 2 are spare ones, 2 y-axis rails, assembly manual/sketch and an extension cable. This cable has to replace the factory installed cable on the SCULPFUN S9 laser machine, because it is much longer in length. Remove the cover on the controller, via the 4 pan head cap screws, on the rear side. Remove the cable, which has a blue, red, white and blue JST-PH and JST XH plugs. Keep this cable in a safe place. Install the new cable and fit the cover. Thats all.