Works it juck works.

Works it juck works.

Works it juck works.

HAVE NOT TRIED IT YET, ONE OF THE CORNERS A LITTLE BENT BUT, NOTHING TO WORRY ABOUT, HOPE TO TRY IT SOON.

HAVE NOT TRIED IT YET, ONE OF THE CORNERS A LITTLE BENT BUT, NOTHING TO WORRY ABOUT, HOPE TO TRY IT SOON.

HAVE NOT TRIED IT YET, ONE OF THE CORNERS A LITTLE BENT BUT, NOTHING TO WORRY ABOUT, HOPE TO TRY IT SOON.

THis plate looks nice, with some finish caveats. The only problem: it is a bit bent, no flat enough, not sure if I will be able to fix this. If I can not use it then I will build a heating chamber for filament dehydration.

THis plate looks nice, with some finish caveats. The only problem: it is a bit bent, no flat enough, not sure if I will be able to fix this. If I can not use it then I will build a heating chamber for filament dehydration.

THis plate looks nice, with some finish caveats. The only problem: it is a bit bent, no flat enough, not sure if I will be able to fix this. If I can not use it then I will build a heating chamber for filament dehydration.