adaptador de energia normal. LED se destaca um pouco, mas não causa problemas.

regular power adaptor. led protrudes a little but doesn’t cause a problem.

adaptador de energia normal. LED se destaca um pouco, mas não causa problemas.

Muito obrigado por seu serviço e Produto i Perceba que o atraso não foi seu.

Many thanks for your service and Product i Realize the Delay was not yours .

Muito obrigado por seu serviço e Produto i Perceba que o atraso não foi seu.

Está bem, está bem

ok

Está bem, está bem

The three power supplies arrived without adequate packaging. One had the faceplate popped off. Whether it started that way or was dropped in transit, I do not know. The connections still appeared sound and the faceplate clicked into place OK. When I connected the units to 240V, one had a red LED indicating "power", another had a green LED, and the third had a LED that did not illuminate (this was not the unit where the faceplate had popped off). I put a multimeter across all three. Two reported ~9.3V while the third reported 9.8V which seems a bit high. The intended use is in Arduino projects so 9.8V won't be a problem but you should probably check the output yourself rather than rely on the compliance plate.

The three power supplies arrived without adequate packaging. One had the faceplate popped off. Whether it started that way or was dropped in transit, I do not know. The connections still appeared sound and the faceplate clicked into place OK. When I connected the units to 240V, one had a red LED indicating "power", another had a green LED, and the third had a LED that did not illuminate (this was not the unit where the faceplate had popped off). I put a multimeter across all three. Two reported ~9.3V while the third reported 9.8V which seems a bit high. The intended use is in Arduino projects so 9.8V won't be a problem but you should probably check the output yourself rather than rely on the compliance plate.

The three power supplies arrived without adequate packaging. One had the faceplate popped off. Whether it started that way or was dropped in transit, I do not know. The connections still appeared sound and the faceplate clicked into place OK. When I connected the units to 240V, one had a red LED indicating "power", another had a green LED, and the third had a LED that did not illuminate (this was not the unit where the faceplate had popped off). I put a multimeter across all three. Two reported ~9.3V while the third reported 9.8V which seems a bit high. The intended use is in Arduino projects so 9.8V won't be a problem but you should probably check the output yourself rather than rely on the compliance plate.