D_man97 can you do a test on 10" or 12" prop. I want a new motor for my old V1 Volantex Phoenix 1600. I think it has a 12x6 prop. could this run it on 3-4s ?

D_man97 Race Ranger always gets hot, work ok, I did 3km in medium-interference environment, it needs plenty of ventilation, I got it for a dron, where that's not a problem when flying. sitting on the table, yes it gets hot even at 200, but not to dangerous levels, even after an hour of work it works fine. but 1.6 with little ventilation is definitely a problem. you'd have to mount it outside, or make some air holes and have good airflow over it.

D_man97 because you ordered the one without electronics... it says you ordered the B061 kit on your review.

D_man97 *after all the revision, the wiring was/is correct, I'm not sure what BF settings were, but I got it working on UBLOX 115000, the real problem is, a poor GPS unit (it's very sensitive to noise), and it's position, close to the VTX antenna, I first got it working to put it in front, on the GoPro mount, and it still needs good 2-3 minutes to fix. cover it with hand and the sats are gone, has to be nice in the open to get so half-decent fix, I even got 11 sats once, but just flying around they move from 5-10. unlike a Beitian BN-880 I got, that one fixes 12 sats in a minute, and goes maybe 1 up/down, this HGLRC loses fix mid flight.