Todas as mensagens

SandyMan69@BG361146061 There are 13 parts in the box. The version I purchased came with 2x batteries, The washer, 2x nozzles, 2x hose adaptors, 1x filter, 1x hose, 1x water/spray bottle, 1x wall charger, 1x au power adaptor and 1x nozzle attachment.

SandyMan69 31/08/2021
The high pressure washer is a good product for light cleaning of your vehicle, paths and other items around the home. It will not clean off heavy dirt so if you go four wheel driving on the weekend and have caked on mud on your car do not expect this cleaner to take the dirt off easily. It does make up for the lack of pressure by being light and convenient with the ability to be run from a garden hose, bucket or even a plastic bottle with supplied fittings. It comes with the washer gun and barrel extension a point nozzle, spray nozzle, hose and several connections as shown in the photos. The batteries supplied are ok however they do not supply much current and get bogged down after around 5-10 minutes of operation. Checking the battery voltage with a meter shows that they are still over 18v but they are down on current and so the washer does not operate fully. So with two batteries I expect around 20 minutes of 50% duty cycle operation. I purchased the unit with two batteries as I have other Makita tools and the batteries are supposed to be compatible. I can confirm that the batteries can power Makita tools but not the sort that draw much current. For instance they power my Makita torch, portable soldering iron etc but not drills, saws etc. as they require more current than the batteries can supply. On the other hand the pressure washer will accept Makita 18v batteries and if you have 5 or 6Ah ones then they will power the washer for a longer time than those supplied with the unit. The batteries supplied with the unit cannot be charged via standard Makita charger (they have their own wall charger) as they lack balance checking inputs and will not fit in the Makita charger.
13
Comentários (4)

SandyMan69@ATWAL Karan As long as your lithium battery is reasonably charged to around 12v when you connect it the controller will assume that it is a 12v system. You can then change the high voltage charge cutoff and low voltage load disconnect to suit you battery's parameters via the display and configuration buttons. In saying that you might have a problem with a 3s battery because I just checked and the minimum charge voltage cutoff is 13v while the minimum low voltage load cutoff is 10v. Those voltages would not be ideal for your battery. If you 3s battery had a reasonable BMS then the 13v max probably would not matter as the battery would disconnect on it's own at around 12.6v but the min load cutoff means your not going to get 100% from the battery maybe that will be good for longevity of cycles though.

BG101520733 24/08/2021
Excellent product which I have purchased and used on previous occasions. The unit comes well packed for shipping and in it’s own box. In the box is the charge controller and a manual which gives installation and configuration instructions in English and Chinese. A diagram of the controller gives clear instructions on how the solar panel input, battery and load output are connected via paired (plus/minus) screw terminals. The controller can be configured via the display and selection buttons. The display is large enough to be read without glasses for most however it is not illuminated so will require an external light source to be read in a dark environment. The controller supports the display of battery voltage, solar panel charge current, load discharge current, accumulated discharge power and accumulated charging power. The controller supports the configuration of battery high voltage disconnection, low voltage disconnection, low voltage re-connection and a load working mode which allows the user to turn the output load off ‘x’ hours after sunset or run the load 24 hours a day. As far as battery types the controller is quite flexible as the high voltage disconnection and low voltage disconnection and fully configurable within the bounds of your system (that is 12 volts or 24 volts). The controller ordered was 100 amp model. The manual for this controller stipulates that it can charge 60 amp to the battery and 30 amp to the load at the same time which only adds up to 90 amps but I guess there must be some leeway for internal currents. Conveniently the controller comes with two USB outputs. These are low amperage outputs. One important thing to remember is to make sure you connect the battery to the controller before solar input and load output and make sure that the battery / batteries you are connecting are reasonably charged. The reason for this is that the controller will sense the battery voltage and set itself up for a 12 volt or 24 volt system.
24
Comentários (5)

Q: São compatíveis com a EINHELL GE-CT 18 LI?

perguntado por alexbarbosa1 sobre 2019-09-09 08:33:51

SandyMan69 The EINHELL trimmer you mention looks the same as the OZITO XPOWER trimmer sold in Australia. If so then these blades will fit your trimmer. The larger hole is 11mm and the smaller is 7mm for your reference. Hope this helps.

2021-11-25 02:19:54 Útil (0)
Enviar
respostas (2)

SandyMan69 No the controller will only output the same voltage as the batteries. To get 12v from a 24v battery setup you will need to add a DC to DC converter to the output.

2021-11-25 02:11:06 Útil (0)
Enviar
respostas (2)

Q: is model without batteries delivered with accessories ( hose, nozzles ...) ?

perguntado por phchauvin sobre 2021-09-04 08:20:57

SandyMan69 Yes you get accessories even when ordering without batteries.

2021-11-25 02:08:10 Útil (0)
Enviar
respostas (3)
BG101520733 24/08/2021
Excellent product which I have purchased and used on previous occasions. The unit comes well packed for shipping and in it’s own box. In the box is the charge controller and a manual which gives installation and configuration instructions in English and Chinese. A diagram of the controller gives clear instructions on how the solar panel input, battery and load output are connected via paired (plus/minus) screw terminals. The controller can be configured via the display and selection buttons. The display is large enough to be read without glasses for most however it is not illuminated so will require an external light source to be read in a dark environment. The controller supports the display of battery voltage, solar panel charge current, load discharge current, accumulated discharge power and accumulated charging power. The controller supports the configuration of battery high voltage disconnection, low voltage disconnection, low voltage re-connection and a load working mode which allows the user to turn the output load off ‘x’ hours after sunset or run the load 24 hours a day. As far as battery types the controller is quite flexible as the high voltage disconnection and low voltage disconnection and fully configurable within the bounds of your system (that is 12 volts or 24 volts). The controller ordered was 100 amp model. The manual for this controller stipulates that it can charge 60 amp to the battery and 30 amp to the load at the same time which only adds up to 90 amps but I guess there must be some leeway for internal currents. Conveniently the controller comes with two USB outputs. These are low amperage outputs. One important thing to remember is to make sure you connect the battery to the controller before solar input and load output and make sure that the battery / batteries you are connecting are reasonably charged. The reason for this is that the controller will sense the battery voltage and set itself up for a 12 volt or 24 volt system.
24
Recomendações
Comentários (5)
SandyMan69 31/08/2021
The high pressure washer is a good product for light cleaning of your vehicle, paths and other items around the home. It will not clean off heavy dirt so if you go four wheel driving on the weekend and have caked on mud on your car do not expect this cleaner to take the dirt off easily. It does make up for the lack of pressure by being light and convenient with the ability to be run from a garden hose, bucket or even a plastic bottle with supplied fittings. It comes with the washer gun and barrel extension a point nozzle, spray nozzle, hose and several connections as shown in the photos. The batteries supplied are ok however they do not supply much current and get bogged down after around 5-10 minutes of operation. Checking the battery voltage with a meter shows that they are still over 18v but they are down on current and so the washer does not operate fully. So with two batteries I expect around 20 minutes of 50% duty cycle operation. I purchased the unit with two batteries as I have other Makita tools and the batteries are supposed to be compatible. I can confirm that the batteries can power Makita tools but not the sort that draw much current. For instance they power my Makita torch, portable soldering iron etc but not drills, saws etc. as they require more current than the batteries can supply. On the other hand the pressure washer will accept Makita 18v batteries and if you have 5 or 6Ah ones then they will power the washer for a longer time than those supplied with the unit. The batteries supplied with the unit cannot be charged via standard Makita charger (they have their own wall charger) as they lack balance checking inputs and will not fit in the Makita charger.
13
Recomendações
Comentários (4)

SandyMan69 The load output from the controller is at the same voltage as the batteries you have connected either a 12v or 24v system is supported by the controller. If you want to run 220v AC bulbs you will need to connect a 12v or 24v DC to AC inverter to the output of the controller or even better directly to the batteries.

2021-11-21 03:10:27 Útil (0)
Enviar
respostas (3)

SandyMan69@BG168102110 I\'m not in the key business either but thought it would be good to learn more about locks and picking.

SandyMan69 30/08/2021
1
Comentários (3)
SandyMan69 17/11/2021
For review is the wireless mini keyboard. The keyboard came packed in standard Banggood plastic bag. Inside the bag the keyboard is presented in it's own box. The box was a little beaten up as a result of it's trip through the postal system but nothing too dramatic happened. Inside the box the keyboard and accessories are well protected. The keyboard comes with a manual and USB charge cable. As for the functionality the main features are the touch pad, scroll buttons, mouse buttons, scroll wheel, volume and home control buttons. All of these work well out of the box when connected to a system running Ubuntu 20.04. We use this system to stream movies to a projector and most of the time it is in a dark room. The main things I like about this keyboard and the reason I purchased it was that the keys are LED backlit and glow when the keyboard is turned on. Using the FN key and Win key together changes the color of the back light or turns the back light off. The keys are backlit via a timer so the backlit turns off after a minute or so to protect the battery life. The back light does not turn on automatically on key press so you need to turn the keyboard off then on again to reset the timer. This is no problem as I always have the keyboard off while watching a movie and only turn it on briefly to start / end the movie. I have used this for almost a month on and off and after charging it initially I have not had to charge it again and it runs fine. One interesting quirk is regarding the keys A, Z, Q and W as you can see they don't follow the qwerty standard. The guy putting it together must have had a bad day :)... No hassle for me as I touch type and only noticed the issue a few weeks after purchase. It makes the keyboard unique. Anyhow very happy with the unit as it does everything I wanted it to do.
1
Recomendações
Comentários (0)

SandyMan69 Theworking pressure may indeed be 30 Bar but the water throughput is not as high as larger washers. In my experience the washer is good for getting light mud and dirt off a car and it is great for applying soap to a car when using the wide spray nozzle but it is not good at removing thick mud when you go four wheel driving etc.

2021-11-16 08:10:59 Útil (0)
Enviar
respostas (2)