Todas as mensagens

Aurum@Alexandre It\'s been a while, but I believe I\'ve changed a resistor in serial to the potentiometer to allow a voltage range less than 5V. In other words changed the ratio of the voltage divider between Vout and the feedback line (potentiometer variable pin).

Aurum 2019-11-15 11:09:26
1
Comentários (2)
Aurum 2019-11-15 11:09:26
1
Recomendações
Comentários (2)

Top reviewers que você pode gostar:

Q: 1. what is the clamping range? 2. can I attach regular drill bits?

perguntado por MannySaunders sobre 2020-10-21 11:48:48

Aurum The range is minimal as it's meant to lock on the rectangular end part of the drill taps. You can put drills in it but why would you? It's not a chuck. Use a proper tool for that.

2020-10-21 02:40:33 Útil (0)
Enviar
respostas (1)

Q: When powered by a common light switch, would it light up automatically?

perguntado por Aurum sobre 2019-08-14 05:30:17

BG201412401 Funciona no 110 v?

2020-09-27 01:25:20 Útil (0)
Enviar
respostas (4)
Aurum 2020-09-15 03:57:18
0
Recomendações
Comentários (0)

Top reviewers que você pode gostar:

Aurum 2020-09-15 03:55:54
0
Recomendações
Comentários (0)

Top reviewers que você pode gostar:

Aurum 2020-07-27 15:46:31
0
Recomendações
Comentários (0)

Top reviewers que você pode gostar:

Aurum 2020-07-27 15:46:31
0
Recomendações
Comentários (0)

Top reviewers que você pode gostar:

Q: Where can I find english data sheet?

perguntado por giuliano sobre 2020-07-24 02:39:17

Aurum Not sure it exists nor you really need one unless you wanna write a driver for the controller chip. Just make a search on google for "arduino ILI9341" or the chip your display uses and you'll find sufficient information.

2020-07-24 03:36:06 Útil (1)
Enviar
respostas (2)

Aurum Make a search on Banggood for "dupont wires", choose male to female, enjoy.

2020-07-15 07:46:22 Útil (0)
Enviar
respostas (1)

Q: How much is the inverters power consumption without a load?

perguntado por Aurum sobre 2018-05-31 04:20:57

Selenochka Idleinverter current, about 0.7A

2020-07-09 04:42:28 Útil (0)
Enviar
respostas (1)

Q: I have the 2.4" unit 240x320. Should the VCC be 5v or 3.3v?

perguntado por BG573543554 sobre 2020-07-07 11:19:09

Aurum The ILI9341 chip was designed for 1.65V ~ 3.3V operation. There is a regulator chip onboard for power, I'm not sure about the data lines though, so safest is to drive it by 3.3V.

2020-07-08 04:15:26 Útil (1)
Enviar
respostas (2)