Todas as mensagens

Q: Which pin is dedicated for Camera Control?

perguntado por srgm_artworks sobre 2019-09-06 03:37:17

Blecheimer69 TX3 port for Smart Audio. You can find the Connection Schematic DIagram under the official Diatone Webside at Support.

2020-09-14 11:56:10 Útil (0)
Enviar
respostas (1)

Marslon emmm,maybe there are no suitable shipping ways

2020-06-03 03:38:14 Útil (0)
Enviar
respostas (1)

Q: PLA? Is it flexible?

perguntado por srgm_artworks sobre 2019-03-15 11:42:06

RemoSaltafossi Tpu and yes, it's flexible. Looks like good enough quality but I couldn't try it because I lost my gopro before I could do so... :(

2020-04-09 05:58:41 Útil (0)
Enviar
respostas (1)
srgm_artworks 2020-03-11 08:34:24
0
Recomendações
Comentários (0)

Top reviewers que você pode gostar:

Q: Which pin is dedicated for Camera Control?

perguntado por srgm_artworks sobre 2019-09-06 03:36:11

Boi vid

2019-12-19 11:48:29 Útil (0)
Enviar
respostas (1)
srgm_artworks 2018-12-15 08:45:09
0
Recomendações
Comentários (0)

Top reviewers que você pode gostar:

srgm_artworks 2018-12-15 08:40:04
0
Recomendações
Comentários (1)

Top reviewers que você pode gostar:

Humbugli236 Suitable for Feiyue 01/02/03 RC Car

2018-11-19 02:49:32 Útil (0)
Enviar
respostas (1)

Q: It is still cheaper to buy them separately...

perguntado por srgm_artworks sobre 2018-11-05 11:54:23

wangshuinong sometime one piece will be more cheaper, if it do promotion like this.

2018-11-17 12:18:39 Útil (0)
Enviar
respostas (1)

Mileaf Valid Payload: Max: 210 g/Min: 75 g just as the official website

2018-05-04 04:28:39 Útil (0)
Enviar
respostas (1)

Q: Which UART number is dedicated foк S-BUS?

perguntado por srgm_artworks sobre 2018-02-02 04:55:28

justindp2006 UART3 is for Serial RX. Make sure you set SBUS inversion to OFF. Depending on fw version it's command serialrx_inverted = OFF or sbus_inversion = off

2018-04-05 08:46:42 Útil (0)
Enviar
respostas (2)

Q: Does it have OSD?

perguntado por srgm_artworks sobre 2017-11-18 04:12:44

Arnror Yes it has. 3 pin in and out at the far left of the board.

2017-12-08 01:16:54 Útil (0)
Enviar
respostas (1)