Todas as mensagens

BG114924485 Thislaser has a power of 15W optical, I put it in replacement of an atomstack of 5.5 w, the 15w is much more powerful, beware of the glare, it is necessary to integrate compressed air to blow the cutting area, to deflect fumes and keep the laser optics clean. cordially Mr H.l

2022-03-21 12:06:29 Útil (0)
Enviar
respostas (1)

Q: Hi - what are dimensions/size for DC Barrel connector?

perguntado por enkoopa sobre 2021-11-04 08:00:46

BG114924485 Hi, Side connection the plug is 2.1mm x 5.5mm on the printed circuit board...mr Hl

2021-12-18 05:08:45 Útil (0)
Enviar
respostas (1)

BG114924485 I think that your request concerns the installation of the cables in a Plastic-Cable-Drag-Chain-Wire-Carrier, there is no on this model, the extension of 850mm with the kit increases the risk of these cables hanging up with the part to be engraved or certain parts of the machine;frame, I extended my Atomstack 5Pro with a profile of 800mm and I had this problem of hooking, I had to redo the wiring to insert it in the chain carrier , since more problem ,cordially Mr Hl. @taradiddle:Good evening, I answered the question @BG110995214 of whether the cables were placed in a chain carrier for this A10 laser! ,I had various problems with the cables of the A5 Pro, without the chain carrier they are often found near the frame or the part to be engraved and can hang these, I put the description and the photos in the section of the Atomstack A5 Pro on the 14 12 2021, cordially Mr Hl

2021-12-14 12:42:10 Útil (0)
Enviar
respostas (2)

Q: Was ist genau PWM, GND, TTL ...?

perguntado por rolando sobre 2020-11-28 04:20:39

BG114924485 " PWM"La modulation de largeur d'impulsions pour régler la luminosité de la LED ;"TTL" "Transistor-Transistor Logic \\\" Un signal TTL est défini comme niveau logique bas entre 0 et 1,4 V, et comme niveau logique haut entre 2,4 V et 5 V, donc la puissance est ajusté par le logiciel (LaserGRBL, LightBurn) qui ajuste la tension du signal TTL ,Comme la Puissance en Watt est défini par La Tension mutiplié par L\\\'ampérage du circuit donc en régulant la tension on ajuste la puissance,(GND c\\\'est \\\"Ground\\\" la \\\"Terre ou la masse\\\" carcasse métallique relier entre elle pour éviter les courants statique qui perturbe les circuits électronique) ,ma déduction sur le sujet , fonctionne trés bien avec L\\\'A5 pro , il Faut une alimentation externe en 12V 5 Amp Stabilisé (entre 10et 20Euros sur Bangood) pour la carte imprimé(Celle sous le support Noir sur la Photo) CORDIALEMENT Hl

2021-10-13 04:09:32 Útil (0)
Enviar
respostas (4)