Todas as mensagens

Q: hi! is this product still available?

perguntado por BG432310341 sobre 2022-05-12 03:24:15

Rii7 You can set a notification when the product will be in stock again.

2022-10-07 04:05:43 Útil (0)
Enviar
respostas (1)

Rii7 The battery leads are the only wires that are exposed.

2022-10-07 04:05:19 Útil (0)
Enviar
respostas (3)

Q: Could I make a business by using it?

perguntado por BG226245177 sobre 2022-04-05 04:22:42

Rii7 Depends on a lot. Hard to make a business out of even more expensive machines. It’s all about your idea and whether this suits that well.

2022-10-07 04:04:46 Útil (0)
Enviar
respostas (2)

Q: matte or glossy first layer finish?

perguntado por Rii7 sobre 2021-10-08 11:58:16

AdilKhadidos It is not glossy.. but gives finish close to that on any power brick.

2022-04-22 05:07:16 Útil (0)
Enviar
respostas (1)

Rii7 Standard resistor size. Length around 35mm and width is very small around 1-2mm.

2022-03-09 03:59:26 Útil (0)
Enviar
respostas (2)

Rii7 No you can only define standby status for example if the power goes out it will be on or off depending what you configure. Cannot be master reset through WiFi.

2022-03-09 03:58:22 Útil (0)
Enviar
respostas (4)

Q: Can I take a shower with this earbuds? Can I washing my head with earbuds?

perguntado por optoclix sobre 2020-01-12 03:47:16

Rii7 If you lather a slight mount of soap between your fingers and coat the earphones, you could probably get it to lather. Then it’s possible to maybe wash your head with earbuds.

2022-03-07 03:38:15 Útil (2)
Enviar
respostas (38)

Q: Hello can I know if I use 5 mm leds to it is it will be damage?

perguntado por BG533717432 sobre 2022-02-25 12:46:49

Rii7 I would assume the board or powersupply and everything else is designed for the included led size and voltage. Changing it would most likely not be bad but also it could damage something. Best case, the leds would be dimmer unless it’s possible to use a higher power supply.

2022-02-27 11:37:18 Útil (0)
Enviar
respostas (1)

Q: vem com molde para os leds?

perguntado por João Paulo sobre 2018-07-06 06:21:25

Rii7 Não inclui.

2022-02-27 11:35:20 Útil (0)
Enviar
respostas (2)

Q: Will this enable me to print TPU flexible plastic?

perguntado por flynnp100 sobre 2020-07-21 03:44:15

Rii7 No it will not. Unless you use it in a direct drive configuration. Technically you can print tpu with a bowden tube, though much more to go wrong. This is just a metal replacement of the stock plastic extruded, everything is exactly the same.

2022-02-14 05:29:48 Útil (0)
Enviar
respostas (7)