DN HXZ 1000 Treinador de Avião RC FPV para Iniciantes com Envergadura de 1000 mm KIT
Uma parte da revisão foi traduzida automaticamente.
Good for FPV. The foam has moderately good quality, great manual, detailed parts.
I bought this for a back up plane for slope flying which it should be great at. It is a super easy build. I set mine up with an EMax 2206.1900kv and have flown it on a 2200, 1300, and 1000 3s. I have some 850 3s on the way. Mine is without LG or tail wheel. It is a gentle and very floaty plane when built light. My only caution is the rubber bands for the wing. I pulled 1 too many G's and the wing lifted off the fuselage and went back into the prop and the plane went nose first into the ground. It will fly again but I am also ordering a second airplane, I like it that much. So,...just mind your rubbers people!
Great product, strong foam. I'm using a 1200kv motor and maidened with 2200mah 3S lipo, will use 1300mah 4S in future. Setup: 1200kv motor, 30A esc, 2200mah 3S/1300mah 4S AUW plane + electronics = 450 gr AUW plane + electronics + FPV pod = 540 gr AUW with 3S 2200mah = 730 gr AUW with 4S 1300mah = 700 gr Maidened in light wind, flew very nice and a bit wobbly at slower speeds. Mods: - re-enforced wings with fiber tape - no landing gear - tilted motor mount down for better thrust angle
good plane,good size
received in good condition..not yet try
This is an interesting little plane. It's a genuine park-flyer. Among the things that it has going for it is that it's lightweight and is made of EPP foam. It's also a plane that comes in a color other than white. The flying weight is around 600g. At one meter this is very light. As others have said it can take up to a 2200mah 3s battery. I think the plane will do fine between 1600-1800mah 3S. My plan for it is to throw a flight controller into it along with a camera, VTX and GPS. I'll make it a lightweight INAV cruiser. I will also laminate the main wing so that it can withstand a bit of abuse I may not even install the landing gear because it seems like it will just bend anyway. Instead, I will go for lamination so that it can keep clean skidding on grass landings. This will get an Emax 2205 2200KV motor with 5" triple blade prop. I will do my best to keep it light so that it can do some mid-range cruising I estimate that with the right configuration it should do 20-30 minute flights. This isn't a good first plane. It's a bit too fragile even with EPP foam. The manual is in Chinese. It comes with a lot of photos so it should be simple to figure out. I think this will be a great plane!
Good tracking information, place seems to be good and cosmic resistant.
No User Manual included :(
Belo avião, ideal para um fpv de curta distância
Very good plane but dont put a 22ookv on it It will pushed down to the ground with 3s lipo 2s lipo and it flies beuatifully with the 2200kv motor not full throttle trim it little bit back in menu of transmitter Seems like 1400 kv is power enough Good quality build!