Opiniões dos clientes

4.75 de 5
Escrever uma crítica
  • Todos Comentários (314)
  • Imagem (18)
  • Vídeo (0)
  • Todas as estrelas
    • Todas as estrelas(314)
    • Estrela(264)
    • Estrela(34)
    • Estrela(6)
    • Estrela(7)
    • Estrela(3)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
Comentários apenas do seu país (Brazil)
|
Mostrar original

Uma parte da revisão foi traduzida automaticamente.

  • 21/02/2021

    Excelente item, trabalhando sem falhas. Com o Domoticz e o RFXCOM estou a usá-lo como um termómetro de frigorífico sem fios, que pode enviar-me mensagens através do Domoticz se a temperatura estiver muito alta (o que significa que alguém provavelmente deixou a porta aberta). Ao tornar o meu frigorífico mais inteligente desta forma simples, Posso combater o desperdício de comida.

    Comentários
    Mostrar original
  • 25/03/2021

    Transporte muito rápido e bom valor para o dinheiro. Infelizmente, não está ligado à estação meteorológica de Oregon Scientific. Bem, 433mhz mas os canais não combinam.

    Comentários
    Mostrar original
  • 17/10/2016

    Le produit est conforme à la description. Parfaitement compatible avec RFXcom (mode Rubiscon) et RFLink. Bien reconnu sous Domoticz. Fonctionne bien avec des accus 1,2V. La finition n'est pas comparable avec celle d'une sonde Oregon ce qui explique en partie la différence de prix. 0,7° à 0,9°C de plus et 3 à 4% d'hydrométrie de plus qu'une sonde Oregon. L'intervalle des mesures est de 30 sec et non pas de 48 sec comme annoncé. Je ne peux pas encore me prononcer sur l'autonomie.

    Comentários (2)
    Mostrar original
  • chmVIP3
    FR
    28/05/2020

    OK, como descrito, bom sensor para o preço. 2a vez que compro este sensor (anteriores 2 anos atrás), ao comparar leituras de sensores, elas são muito semelhantes (mesmo % para H, apenas diferença de 0,1 °C para T). Além disso, este sensor é reconhecido pela RFLink. Melhor leitura do monitor do que o Digo R8S. A qualidade plástica da tampa da bateria poderia ser melhor, mas tem um selo. Não gosto do grande logótipo da Daniu.

    Comentários (1)
    Mostrar original
  • RobVIP1
    NL
    01/02/2019

    Works great. I have 12 connected to my domoticz raspberry pi using RFXcom. I was having 'difficulty' with two thermometers. One was working previously and the other was new. After resetting the new one, I could again read all 12 of them. I think they were both sending at exact the same time. Resetting one gave it a new 'sending-slot' and so the other was also able to connect again.

    Comentários (1)
    Mostrar original
  • 08/01/2016

    The device has a battery compartment that is fixed with 4 screws. Behind this lid you will find: - Two AAA battery locations - a Transmit button, to force a single frame transmit - an address slide switch with 3 positions. - a switch to toggle between C / F Since I bought 3 I used the available addresses. I linked them up to my RFXcom to see data frame type (see picture) The three devices were laying next to each other for an hour. whereafter the measured values were precise(values close to eachother. The accuracy I did not test. The transmission repeat rate is about two measurements per minute. Something I would like to know is the expected battery life.

    Comentários (2)
    Mostrar original
  • 30/05/2017

    I'm using RFXcom433E (last firmware 1019 and Domoticz) and i only get Temperature information! I was expecting also Humidity but nothing apears, can you help me please ?

    Comentários (2)
    Mostrar original
  • 03/04/2019

    J'ai commandé 8 sondes, le prix est parfait. Elle fonctionne très bien avec un RFXCOM, je mets que 2 étoiles pour la qualité car sur les 8 sondes placées au même endroit, 6 indique la même chose à 0.1°C de tolérance. par contre 2 sondes sont totalement décalées 2°C d'écart entre les deux

    Comentários
    Mostrar original
  • 18/03/2017

    It looks like a good remote sensor for a 433 MHz thermometer system. But I was not able to get it to handshake with a few such weather stations. This in no way means this is a bad sensor. Quite the contrary, it appears well made, good features, good and bright display. But you must know which temperature / humidity base station it is compatible with. .... Another possibility is that I might have received a defective unit. Those things happen. The monitoring red LED which is supposed to flash each 60 seconds, I was not able to catch a time when it flashed. I may have missed it. Possibly it only flashes after handshaking with a base station. For anyone with engineering knowledge, who might know the various 433 MHz thermometer systems, no doubt such a person could make this sensor register with the appropriate base station. But I have no complaints. I am likely not knowledgeable enough to know which of the 433 MHz systems will work with this sensor...... I like the fact it has a switch to use Channel One or Channel Two or Channel Three. This suggests it can work with base stations accepting 3 remote sensors. No complaints. Toronto, Canada

    Comentários
    Mostrar original
  • 08/10/2017

    I have ordered 3 of these sensors to add on my home automation system working with domoticz and a rfxcom. The 3 sensors worked out of the box after putting batteries in it. Very good value for the price.

    Comentários
    Mostrar original
Show:

    Total 0 Páginas

    Vá para página

    Vai

    Você pode estar interessado em

    recommendation for you
    • R$38,37
    • R$13,72
    • R$53,31
    • R$42,64
    • R$53,31
    • R$53,31
    • R$47,98
    • R$58,65
    • R$138,70
    • R$104,49
    • R$1.067,28
    • R$1.867,78
    • R$288,13
    • R$69,32
    • R$90,67
    • R$101,34
    • R$101,34
    • R$31,97