Banggood

This is a great item, I have ordered another I like it so much. You need to set NTF_Display_Type = 1 to make it work. REboot the flight controller once set to have it start.

This is a cool little device however you must set via Mission Planner. NTF_Display_Type to 1 to enable the device and then reboot the flight controller for the device to work.

Shipping was fast and item arrived undamaged and as advertised.

works very well at indicating the status of the pixhawk much easier than decoding the light flashing it will display a couple of key parameters and was easy to set up.

My display works properly when my pixhawk 2.1 is powered by usb. When I power pixhawk 2.1 from batteries, the device does not light up. It seems to be a voltage issue (I'm running arduplane 3.8).

Display Para prevuelo, excelente solución para observar lo esencial el APM. Precaución solo funciona con Arducopter 3.5.3, debes habilitar la opción a través de Mission Planner. NTF_Display_Type a 1 para habilitar el dispositivo.

Good to read inside but not in the sun if it works. It always freeze after some minutes with a genuine Pixracer. Therefor not in use.

works great see this site and pictures CUAV PIX_DISPLAY I2C OLED Monitor for Pixhack/Pixhawk FPV Multicopters

OK. Qualidade.

tudo certo