Opiniões dos clientes

4.99 de 5
Escrever uma crítica
  • Todos Comentários (107)
  • Imagem (15)
  • Vídeo (0)
  • Todas as estrelas
    • Todas as estrelas(107)
    • Estrela(106)
    • Estrela(1)
    • Estrela(0)
    • Estrela(0)
    • Estrela(0)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
Comentários apenas do seu país (Brazil)
|
Mostrar original

Uma parte da revisão foi traduzida automaticamente.

  • 17/04/2018

    Mosfet używam z drukarką Anet A8 do sterowania stołem, pracował dobrze, nie grzał się. Jednak po kilkunastu godzinach pracy tranzystor dostał zwarcia, grzałka stołu cały czas była włączona mino jej wyłączenia na płycie głównej drukarki. Wymieniłem na płytce tranzystor na inny z moich własnych zapasów i działa do tej pory.

    Comentários
    Mostrar original
  • 30/03/2018

    my HEVO is waiting for these, i `ve fried my ramps feeding the heat bed so i dicided to test with by pass and drawn the curret by it.

    Comentários
    Mostrar original
  • 09/08/2017

    Good augrade for 3d printer

    Comentários
    Mostrar original
  • 10/03/2018

    This item is 100% sufficient and the cheapest Offer i found. Works on my Anet A8 12 V heatbed. Power while heating from 20C° about 13,5A / 162Watt. So this item is not getting even hand warm. :)

    Comentários
    Mostrar original
  • 10/12/2017

    Item as described and shown in the photo

    Comentários
    Mostrar original
  • 29/03/2018

    very high quality high current Mosfet driver highly recommended as an upgrade for a 3d printer takes the load off the main board

    Comentários
    Mostrar original
  • 27/02/2018

    ottimo prodotto testato su stampante raiscube 2 per evitare di surriscaldare la scheda madre

    Comentários
    Mostrar original
  • 23/03/2018

    Good MOSFET switch with optical isolation, works as expected.I use it for 24V Heatbed and for 12V printhead heater.

    Comentários
    Mostrar original
  • 19/11/2017

    The white wire is a little bit short and need a washer / plastic plate to protect the back. But it works well.

    Comentários
    Mostrar original
  • 11/09/2017

    bon produit, fait sont boulot, fils tres fin mais ca va

    Comentários
    Mostrar original
Show:

    Total 0 Páginas

    Vá para página

    Vai
    recommendation for you
    • R$12,19
    • R$93,73
    • R$26,00
    • R$20,79
    • R$18,03
    • R$187,51
    • R$75,13
    • R$36,42
    • R$8,49
    • R$7,50
    • R$1.297,28
    • R$1.140,98
    • R$958,58
    • R$207,98
    • R$176,67
    • R$19,28
    • R$2.339,28
    • R$9,64