Opiniões dos clientes

4.76 de 5
Escrever uma crítica
  • Todos Comentários (144)
  • Imagem (31)
  • Vídeo (2)
  • Todas as estrelas
    • Todas as estrelas(144)
    • Estrela(127)
    • Estrela(9)
    • Estrela(2)
    • Estrela(2)
    • Estrela(4)
Ordenar por:
Comentários Anteriores
  • Comentários Anteriores
  • Mais úteis
  • Mais Recente
Comentários apenas do seu país (Brazil)
  • June-14 2018 04:37:42

    Ok when i first received these ESC's i had issues, and i did complain to banggood, however i since discovered that the mounting holes on these boards are 'live' so you MUST use plastic stand off's, i have recommended to bang good that this be added to the description, Once that was sorted i was able to use the ESC's and they are great, Blheli_S and running DSHOT 600 on a 2" quad feels awesome good product but do remember about running plastic stand offs (i was using carbon)

    Comentários (1)
  • anyVIP4
    March-08 2018 08:41:46

    Ключи по углам расположены близко к крепежным отверстиям, не подрезая стойки разместить плату не получится. Контакт питания отмеченый тут как VCC на деле не подключен, в схеме которая идет в комплекте указано правильно - NC.

  • July-04 2019 01:10:24

    Purchased this to swap out another 4in1 ESC that was causing lots of issues with wiring and mounting when using a smaller FC. Easy to solder, but best to use a small tip as some components are a little close to the pads. Handles the current draw and braking on build with 3S and 4S. No issues. Recommended for FC with same mount size.

  • May-01 2018 06:48:37

    прсле того как на моторах 1104 7500KV на мощной 3S-батарее сжег уже второй регуль (первый был 4х10А второй 4х20А) решил купить этот регуль его должно хватить 😁

  • December-09 2017 14:43:18

    Great esc, it´s easy to solder the motor wires but to solder the power wire there is not a lot of space to solder them on. Would be good if there was more space around the solder pads.

    Comentários (1)
  • December-01 2017 12:43:35

    Good ESC high current capable 28A per motor! Be aware it doesn’t have a BEC. So if you plug it in your FC with the red wire the FC will get VBAT. Some FC’s only take 5V in that case remove the red wire or you will some your FC

  • November-25 2018 22:18:52

    Works Great, Looks Great, sized great! It does have small pads but if you are even somewhat skilled even beginner skilled at soldering you should have no problems hooking everything up.

  • April-07 2018 10:47:46

    This 4in1 is a direct replacement for the 10amp 4in1 found in the lizard 95 and the same as the lizard 105 and eachine mini cube but with far more avalable ampage

  • February-21 2018 15:51:31

    I fried the ESC on my Leader 120 shortly after receiving the unit. This ESC is a direct replacement and runs just as well as the original. Great for a spare in case yours goes bad

  • January-23 2018 00:06:33

    There's basically no caps on this board so add some for sure. I'll be putting this to the test on lightweight 5inch. plugged it in to blheli, comes with 16.6. didn't blow up on 4s in. I'll update if it can handle the amps it says

    Comentários (3)

    Total 0 pages

    Go to page


    Você pode estar interessado em

    recommendation for you
    • R$151,73
    • R$15,76
    • R$366,22
    • R$166,43
    • R$144,24
    • R$65,26
    • R$175,09
    • R$173,59
    • R$466,12
    • R$83,19
    • R$189,63
    • R$84,91
    • R$15,59
    • R$20,81
    • R$60,99
    • R$503,91
    • R$194,18
    • R$44,34